User's Manual
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Setup Menu
- Chapter 6 Troubleshooting and Diagnostics
- Appendix A Interface Specifications and Cable Diagrams
- Appendix B Boot Manager
- Appendix C SNMP Management
- Appendix D Glossary
- DC Power Supply Connection
- Customer Response Form
![](/manual/rad-data-comm/modular-access-device-with-integrated-router/user-s-manual-english/images/img-24.png)
Chapter 1 Introduction FCD-IPM Installation and Operation Manual
1-8 Functional Description
Time Slot Handling
FCD-IPM allows the user to configure each of the individual time slots freely
according to the following options:
• Data link1 – for data from router/bridge
• FIX SUB Voice – for voice from sublink
• FIX SUB Data – for data from sublink
• FIX Voice (1, 2, 3, 4) – for analog voice port 1, 2, 3, 4
• I/O1 Voice (1, 2, 3, 4) – for analog voice port 1, 2, 3, 4
• I/O2 Voice (1, 2, 3, 4) – for analog voice port 1, 2, 3, 4
• I/O1 SUB Data – for data from sublink
• I/O2 SUB Data – for data from sublink
• I/O1 SUB Voice – for voice from sublink
• I/O2 SUB Voice – for voice from sublink
• I/O1 Channel – for n x 64/56 data port
• I/O2 Channel – for n x 64/56 data port.
For more information on configuring time slots, refer to Chapter 4.
Integrated Router
IP Router
FCD-IPM as an IP router supports:
• Static IP net configuration
• Dynamic IP net learning using RIP and RIP-2 protocols
• CIDR topologies
• Multiple IP nets on the LAN
• Numbered and unnumbered interfaces
• IP fragmentation
• RIP1, RIP2 & OSPF Routing Protocols.
IPX Router
FCD-IPM also supports standard IPX routing that includes support for RIP and SAP.
Bridging
FCD-IPM supports bridging. The bridge is used to interconnect a number of LANs
by accessing layer 2 (MAC layer). FCD-IPM automatically extends the scope of any
interface, allowing the interface to interconnect several networks, providing that all
supported interfaces are set to bridge mode.