Specifications

Chapter 1 Introduction Installation and Operation Manual
1-2 Physical Description Optimux-106 Ver. 6.1
Figure 1-2. Typical Optimux-106 with USER ETH Application
Features
Optimux-106 is a compact 1U high, ½ 19-inch wide unit that multiplexes four T1
channels and an optional 10/100BaseT USER Ethernet port over a T2 fiber optic
uplink.
The unit transmits over multimode, single-mode, or single mode over single fiber
(WDM) using LED, VCSEL, or laser diode transmitters for a range up to 120 km
(74.5 miles).
Optimux-106 can be ordered with two uplink interfaces, where the second link
interface operates as a backup for the main link. The user can select automatic
switching to the backup or manual selection of the desired link interface.
Optimux-106 can be powered from 100-240 VAC or -40 to -72 VDC power
supplies. Two independent power supplies can be installed for redundancy.
The device can be managed using an ASCII terminal, an SNMP management
station, or an Ethernet link using Telnet or a Web-based management interface.
Optimux-106 conforms to the following standards: ITU G.703, G.824, G.955,
IEEE 802.3.
1.2 Physical Description
Figure 1-3 shows a 3D view of the Optimux-106 unit in the plastic enclosure. The
plastic enclosure is a compact 1U high, ½ 19-inch wide unit. The location of LEDs
and connectors on the metal enclosure is similar.
The front panel includes several LEDs, which display the status of power, data
flow and diagnostics. For a detailed description of the front panel, see
Chapter 3 .