Specifications

Optimux-106 Ver. 6.1 Site Requirements and Prerequisites 2-1
Chapter 2
Installation and Setup
Optimux-106 is delivered completely assembled. It is designed for operation as a
desktop unit or for mounting in a 19-inch rack. For instructions on rack mounting,
refer to the
Rack Mounting Kit for 19-inch Racks guide that comes with the RM kit.
Mechanical and electrical installation procedures for Optimux-106 are provided in
the following sections.
After installing the unit, refer to
Chapter 3 for system operating instructions.
In case a problem is encountered, refer to
Chapter 5 for test and diagnostics
instructions.
No internal setting, adjustment, maintenance, or repairs may be performed by
either the operator or the user; such activities may be performed only by a skilled
technician who is aware of the hazards involved.
Always observe standard safety precautions during installation, operation, and
maintenance of this product.
Before installing the product, review Handling Energized Products at the
beginning of the manual.
2.1 Site Requirements and Prerequisites
Power
Install Optimux-106 units powered by the wide-range AC/DC power within 1.5m
(5 feet) of an easily accessible grounded AC outlet capable of furnishing a supply
voltage in the range of 100-240 VAC or -40 to -72 VDC.
Tributary Connections
The tributary interface has four RJ-45 connectors. If ordered, there is an RJ-45
connector for the USER-ETH port.
Appendix A shows the pin allocation for the RJ-
45 connectors.
The maximum allowable line attenuation between each tributary port and the
user's equipment is 6 dB.
Warning
Note