Specifications

Chapter 6 Software Upgrade Installation and Operation Manual
6-8 Upgrading Optimux-106 Software via the Boot Menu Optimux-106 Ver. 6.1
The Send File window is displayed:
 Select the prescribed Optimux-106 software file name (you may use
the Browse function to find it).
 In the Protocol field, select XMODEM.
 When ready, press Send in the Send File window. You can now monitor
the progress of the downloading in the Send File window.
If downloading fails, repeat the whole procedure.
5. When the downloading process is successfully completed, you will see a
sequence of messages similar to the following:
Loading ...
Decompressing to RAM.
Processing archive: FLASH
Extracting OP106.BIN
..........................................................
.................................................................... CRC OK
Running ...
*******************************************************************
* In order to start working - press the ENTER button for few times*
*******************************************************************
6. At this stage, press the <Enter> key several times to go to the log in screen.
Using the TFTP
Use the following procedure to download software release to Optimux-106 via
TFTP.
1. Verify that the *.img file is stored on the PC with the TFTP server application.
2. Define IP parameters via the Boot Manager menu.
3. Activate the TFTP server application.
4. Download the *.img file from the PC to Optimux-106.
³ To define IP parameters via the Boot Manager menu:
1. From the Boot Manager menu (
Figure 2-3 ), select System Configuration to
start the configuration of the Optimux-106 IP communication parameters, as
needed for TFTP transfer.
The parameters are displayed in consecutive lines. For each parameter,
you can accept the current values by simply pressing <Enter> to continue,
or type a new value:
 IP Address: used to select the IP address of Optimux-106. To change
the current value, type the desired IP address in the dotted quad
format, and then <Enter> to continue.
Note