System information

Chapter 3 Configuration Management IPmux-8/16 User’s Manual
3-16 Configuring General Parameters
You have the following options:
• Add a VLAN
• Change a VLAN
• Remove a VLAN
 To add a VLAN to the VLAN Table:
1. Click Add.
The Add VLAN dialog box appears.
2. Configure the desired parameters.
3. Click Apply.
The VLAN, if valid, is added to the VLAN Table.
4. Click Close.
The Add VLAN dialog box is closed and the new entries are added to the
end of the list in the VLAN Table Dialog Box.
• You can sort the list according to the desired column by clicking on the column
heading.
• Add is disabled when there are 64 entries in the table.
Figure 3-13. VLAN Table – Add VLAN Dialog Box
 To change a VLAN in the VLAN Table:
1. Select the row you wish to change.
2. Click Change.
The Change VLAN dialog box appears.
3. Configure the desired parameters.
4. Click Set.
The VLAN Table is updated.
If no port is selected to be member of this VLAN then the VLAN is removed.
5. Click Close.
The Change VLAN dialog box is closed.
Note
Note