System information

Chapter 3 Configuration Management IPmux-8/16 User’s Manual
3-18 Configuring IPmux-8/16 Ports at the Physical Layer
Figure 3-15. Ethernet Interface Parameters Dialog Box
Table 3-9. Ethernet Interface Parameters
Parameter Possible Values / Remarks
Slot 1, 2
Note: This does not appear for OOB.
Port ETH1, ETH2, Control (OOB)
Note: OOB means out-of-band
Auto Negotiation Enable (checked), Disable (unchecked)
Note: Disabled for Control (OOB) port
Max Capability
Advertised
Defines the maximum capabilities of the interface
Only applicable when Auto Negotiation is enabled (checked)
10BASE-T half duplex mode, 10BASE-T full duplex mode,
100BASE-TX half duplex mode, 100BASE-TX full duplex mode
Note: Working in half duplex mode is not optimal and might cause communication
problems. Disabled for Control (OOB) port
Default Type Only applicable when Auto Negotiation is disabled
10BASE-T half duplex mode, 10BASE-T full duplex mode,
10BASE-TX half duplex mode, 10BASE-TX full duplex mode
Rate Limit (kbps) The maximum rate permitted to transfer via this port, in Kbps:
Disable, 256, 512, 1000, 2000, 4000, 8000, 16000, 20000, 32000, 40000,
64000, 80000
Note:
• 32000, 64000 exist for User port only
• If Rate Limit field has been changed to or from Disable then a message-box will
open: “Changing Rate Limit may disconnect the Agent for 30 seconds”.
Click OK to set the new parameters.