System information

Chapter 3 Configuration Management IPmux-8/16 User’s Manual
3-24 Configuring IPmux-8/16 Ports at the Physical Layer
Configuring Internal T1 Parameters
 To display or configure Internal T1 port parameters:
1. Click an Internal T1 port.
2. Configuration > Parameters...
The T1 Parameters dialog box appears.
Figure 3-18. Internal T1 Parameters Dialog Box
Table 3-11. Internal T1 Parameters
Parameter Possible Values / Remarks
Slot 3, 4
Port CH1..CH28
Type T1
Suppress Port
Indication
Defines whether Agent will mask port's alarms and statistics or not
Unchecked
(don’t mask), Checked (masked)
Line Type Line type affects the number of bits per second that the link can reasonably carry. It also
affects the interpretation of the port performance statistics.
ESF: Extended SuperFrame
D4: AT&T D4 format
Unframed: Use when the data being transmitted is unframed
Restore Time
(sec)
1, 10
Used to change the sync. Algorithms to reduce the time required for the port to return to
normal operation after a RED (LOF - loss of frame synchronization) alarm.
Note: Not applicable when the Line Type is Unframed
Transmit AIS Enables/disables AIS transmit when Ethernet cable (for TDMoIP) is out (disconnected)
Enabled, Disabled