System information

IPmux-8/16 User’s Manual Chapter 3 Configuration Management
Managing Bundle Connections 3-31
Creating Bundle Connections
For information on creating and managing bundle connections using the Service
Center map, refer to chapter 7 of the RADview SC/TDMoIP System Manual.
Removing Bundle Connections
For information on removing bundle connections using the Service Center map,
refer to chapter 7 of the RADview SC/TDMoIP System Manual. In cases where a
circuit is broken, you may use the bundle connection table to manually remove a
bundle connection.
 To view the bundle connection table:
• Configuration > Bundles > Bundle Connection Table…
The Bundle Connection Table appears.
Figure 3-23. Bundle Connection Table
Table 3-16. Bundle Connection Table Parameters
Parameter Possible Values/Remarks
Slot No. / Channel No. Slot or channel to be configured
For slots: 1 to 4
For channels: 1 to 8
Bundle No. For E1: 1 to 496
For T1: 1 to 384
In slot 3 for Card Type = E1/T1, T3/E3: Bundle number = 1
In slot 4 for Card Type = T1: Bundle number = 193
In slot 4 for Card Type = T3/E3: Bundle number = 249
Bundle Name Bundle name for selected channel.
Admin. Status Connected, Disconnected (frames will not be sent from this channel)
Oper. Status Connected, Disabled, Remote Fail, Local Fail
Dest. Name Logical name or IP address of the destination IPmux-16
Next Hop Indicates IP address to which the Ehternet frame will be sent when the Dest. Name
IP is not in the device subnet