Owner`s manual

Preparation
3
2. Place the batteries in the compartment as indicated by
the polarity symbols (+ and –) marked inside the
compartment.
3. Replace the cover. When the batteries are low,
ò
appears and the recorder automatically shuts off.
Replace batteries as soon as possible.
±
5'66+0)"6*'"%.1%-
1. Press and hold
ERASE
for more than two seconds in
clock mode. The hour digits flash.
2. While the hour digits flash, repeatedly press or hold
down
#
or
,
to set the hour, then press
â
to store the
setting.
3. Repeat Step 2 to set the minute, month, day, and year.
4. Press
REC/STOP
to store the adjusted time and date.
±
%100'%6+0)"'#42*10'5
You can use an optional mono earphone with a
1
/
8
-inch (3.5
mm) mini-plug to listen to your recordings in private. Your
local RadioShack store carries a wide selection of
earphones.
Insert the earphone's plug into the recorder's
EAR
jack. The
built-in speaker automatically disconnects.
±
.+56'0+0)"5#('.;
To protect your hearing, follow these guidelines when you
use earphones.
• Set the volume to the lowest setting before you begin
listening. After you begin listening, adjust the volume to
a comfortable level.
• Do not listen at extremely high volume levels. Extended
high-volume listening can lead to permanent hearing
loss.
• Once you set the volume, do not increase it. Over time,
your ears adapt to the volume level, so a volume level
that does not cause discomfort might still damage your
hearing.
64#((+%"5#('6;
Do not wear an earphone while operating a motor vehicle or
riding a bicycle. This can create a traffic hazard and could
be illegal in some areas.
±
"016'"
±
"
Installing Batteries
When you replace the batteries,
the display may become blurred
and will gradually increase in
sharpness.
Setting the Clock
If you do not press a button for
about 10 seconds, the recorder
automatically exits the time-setting
mode.
Connecting Earphones
You can also use an earphone to
monitor what the recorder picks up
through the internal microphone or
an external microphone.