- RadioShack AC-to-DC Power Adapter Quick Start Guide

ManualsBrandsRadio Shack ManualsNetwork Card273-1668

13.5/30VDC • 1000mA

AC-to-DC POWER ADAPTER

273-1668

RF Emission Information

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Modifying or tampering with your 13.5/30VDC 1000mA AC-to-DC

Power Adapter’s internal components can cause a malfunction, which

might invalidate its warranty and void your FCC authorization to

operate it.

are trademarks used by RadioShack Corporation.

11A07

273-1668

Printed in China

Using your Adapter

1. Plug the correct size

Adaptaplug onto the jack at

the end of the adapter’s cord.

• If your device’s DC input jack is marked , align TIP

on the adapter’s jack with + on the Adaptaplug (shown).

• If the DC input jack is marked , align TIP on the

adapter’s jack with – on the Adaptaplug.

CAUTION: Be sure to set the correct tip polarity. Incorrect polarity

can damage your device or the adapter.

2. Plug the Adaptaplug into your device’s DC input jack.

3. Set the adapter’s voltage switch to the correct setting.

4. Plug the adapter into an easily accessible power outlet located

near the equipment.

Cautions:

• If this adapter is not compatible with the voltage and current

requirements of your portable device, it can result in PERMANENT

DAMAGE to the device.

• Before using, consult the User’s Guide or the rating label on your

device to make sure it requires 13.5 or 30 volts DC.

• The power adapter’s current (1000mA) must be equal to or more

than the current needed by your portable device.

• Before charging cell phones, make sure the cell phone

speciﬁcations are supported by this power adapter.

• Never operate the adapter if it has been damaged in any way. Do

not disassemble it.

WARNING: To prevent ﬁre or shock hazard, do not expose the

adapter to rain or other moisture.

CAUTION: The total combined current for accessories plugged into

this adapter must not exceed 1000mA.

Summary of content (1 pages)

PAGE 1
3.5/30VDC • 1000mA 273-1668 AC-to-DC POWER ADAPTER Using your Adapter RF Emission Information 1. Plug the correct size Adaptaplug onto the jack at the end of the adapter’s cord. • If your device’s DC input jack is marked , align TIP on the adapter’s jack with + on the Adaptaplug (shown). • If the DC input jack is marked , align TIP on the adapter’s jack with – on the Adaptaplug. CAUTION: Be sure to set the correct tip polarity. Incorrect polarity can damage your device or the adapter. 2.