Wireless Office Headset User Manual

12
SETTING THE RINGER
VOLUME
To adjust the ringer volume on the cord-
ed base phone, slide the switch on the
right side of the base to
RINGER OFF
,
LOW
or
HI
.
If you do not want the ringer to sound,
slide the switch to
OFF
. You can make
calls with the ringer off, and you can an-
swer calls if you hear another phone on
the same phone line ring.
Note:
To temporarily turn off the head-
set’s ringer while the phone rings, press
VOL
8
88
8or9
99
9on the side of the headset,
or
VOLUME
8
88
8or9
99
9on the remote dial
card. The headset’s ringer turns back on
when you hang up the phone.
ADJUSTING THE
HEADSET
1. Press
VOL
to set the volume to
the lowest level, then place the
headset on your head with the
microphone in the front.
2. If necessary, adjust the headset
band on both sides by pulling down
or pushing up on each end until it
fits with almost no pressure on your
ears or the top of your head.
3. Pull down the microphone, adjusting
it to about even with your chin.
Experiment until you find the most
comfortable position.
Caution:
The microphone swivels
on the headset. Do not bend the
microphone while you adjust it.
Note:
If you hear a dial tone when
you pull down the microphone,
press
OFF
on the infrared remote
dial card.
When you are not using the headset,
place it on the headset charger. Other-
wise, you might need to repeat these
adjustments.
RINGER OFF
LOW-HIGH
TONE
PULSE
43-007.fm Page 12 Wednesday, March 22, 2000 11:24 AM