Wireless Office Headset User Manual

18
3. Enter the number you want to store
(up to 20 digits can be stored),
including any pause or tone entries
(see “Entering a Pause in a Memory
Number” on Page 18 or “Using Tone
Service on a Pulse Line” on
Page 17).
4. Press
MEMORY
on the base. The
phone rings to indicate that the
number is stored successfully.
Notes:
• If you make a mistake while entering
the number, press
PROGRAM
to
exit. A beep sounds. Start again at
Step 1.
• You cannot store a memory number
if the headset is not connected.
Entering a Pause in a Memory
Number
In some telephone systems, you must
dial an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. To enter a
2-second pause (for an access code, for
example), press
HOLD
at the appropri-
ate point when you store a number.
Note:
Each pause entry uses one digit
of memory.
Dialing a Memory Number
To dial a number stored in direct memo-
ry, press
M1
on the base, or
MEM
then
00
on the infrared remote dial card for
headset use.
To dial a number stored in memory,
press
MEMORY
(or
MEM
on the remote
dial card), then enter the desired memo-
ry location number (
01
–
20
).
MEMORY
M1
MEM
43-007.fm Page 18 Wednesday, March 22, 2000 11:24 AM