User Manual

产品特性
通道个数：4通道
频率范围：2400-2483.5Mhz
供电范围：4.5-8.4V
信号格式：D8/D16v1/SFHSS
输出格式：PWM
控制距离：大于1km
天线长度：15厘米
尺 寸：30*15*5毫米
重 量：3克
Receiver Specifications
Channels: 4
Frequency range: 2400-2483.5Mhz
Power input range: 4.5-8.4V
Signal format: D8/D16v1/SFHSS
Output format: PWM
Control distance: more than 1km
Antenna length:15cm
Size:30*15*5mm
Weight:3g
失控保护
1. 接收机通电10秒内，按一次BIND按钮，接收机将保存遥控器当前所有通道值，作为失控保值
2. 接收机通电10秒之后，BIND按钮功能将被停用，以防止飞行时误触更改失控保护设置
R84接收机用户指南
R84 Receiver User manual
Fail-safe Protection
1. Press the BIND button once within 10 seconds of the receiver being powered on, and the
receiver will save all the current channel values of the remote control as the fail-safe value.
2. 10 seconds after the receiver is powered on, the BIND button function will be disabled to
prevent accidental changes to to the fail-safe settings while preparing the model for flight.
CH1/2
CH3/4 CH3 CH4
CH1 CH2
R84
DC4.5-8.4V
2.4GHz
V2
对频方法
1. 将遥控器开机并选择所需协议；
2. 按压接收机对频开关并对接收机通电；
接收机在三个协议之间循环并以灯号表示。
单闪-单闪-单闪= D8协议；
双闪-双闪-双闪= D16协议；
三闪-三闪-三闪= S-FHSS协议；
3. 当接收机闪灯对应遥控器协议时， 按下遥控器BIND按键。 灯号快闪后常亮 表示对频完成；
4. 对接收机重新供电。
Bind Method
1. Turn on your transmitter and select the desired protocol.
2. Enter bind mode on the receiver. Press and hold the bind button while powering on the
receiver.
The receiver will cycle between D8, D16 and S-FHSS protocols.
Three single flashes= D8 protocol.
Three double flashes= D16 protocol.
Three triple flashes= S-FHSS protocol.
3. When the flash pattern matches the transmitter protocol, press bind on the transmitter. The
light will flash rapidly then return to solid.
4. Cycle the power to the receiver after binding.