Instructions / Assembly

8
Mounting
Bracket
Canopy
Canopy
Screws
Screw
Blade
Fig. 10
Fig. 11
Slide the ceiling canopy up into place over the
ceiling mounting bracket. Slide rubber canopy
cover into place. The two screws on the mount-
ing bracket face should slip through the key hole
slots in the canopy (see gure 10).
Step 7 Attaching the Ceiling Canopy,
Depending on how deep the
electrical junction box was
installed in the ceiling, you
may have a slight gap
between the ceiling canopy
and the ceiling.
Step 8 Fan Blade and Blade Arm Assembly
Junction boxes are commonly installed at dier-
ent depths in the ceiling, so we have designed
the mounting bracket and canopy to allow for
this
Mos fans are supplied with a
reversible blade nish. Choose the blade nish
that you prefer and attach as follow:
Attach each fan blade to a blade arm with four (4)
3/16” x 1/2” washer head screws and four (4)
3/16” screw pads (see gure 11). DO NOT
OVER TIGHTEN THESE SCREWS.
Screws should be tightened until the screw pads
are compressed by the screw head. Hold the
Blade Arm decorative side down
and place the
blade on top with the at side of the blade facing
down. Each screw is passed through the screw
pad and blade and screwed into the blade arm.
Blade Arm
Rubber
Canopy
Cover