Specifications

EPC-8A Hardware Reference

Exit Menu

Use the options in this menu to save and exit, or abandon your changes and exit to the system.

ULA Selects the unique logical address (ULA). Possible values range

from 00 through FF.

The logical address controls where in the VME A16SD space the

EPC-8A extended registers are mapped. If the ULA=0, the

registers are at C000. If the ULA=FF, the registers are at FFF0.

In general, the registers map to [C000 + (ULA*40)] (all numbers

in hexadecimal).

Field Description

Save Changes & Exit Saves the values you just entered and exits to load the operating

system. The new values are loaded, and you exit and reboot.

Discard Changes & Exit Discards the changes you just made and revert to the BIOS as it

was before you started. The system boots with the old values.

Get Default Values Resets the BIOS values to the original, default values set at the

factory, before any suppliers or other end users made changes.

Backup CMOS to Flash Immediately saves current Setup settings to CMOS RAM and

into FBD main block #1.

Restore CMOS from Flash Immediately restores CMOS RAM and updates current Setup

settings from FBD main block #1.

Erase CMOS from Flash Immediately erases the CMOS image from the flash.

CMOS Restore Condition Determines under what conditions the System BIOS restores

CMOS RAM from FBD main block #1 when booting. Restore

conditions include: Always, Never, and CMOS Corruption (default).

Load Previous Values Loads the system with the previous values before this editing

session started. You do not exit.

Field Description

Figure 3-12. Exit menu

Main Advanced EXM VME

Save Changes & Exit

Discard Changes & Exit

Get Default Values

Backup CMOS to Flash

Restore CMOS from Flash

Erase CMOS from Flash

CMOS Restore Condition: [Bad CMOS]

Load Previous Values

Save Changes

Exit & Update BIOS

Item Specific Help

F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults

ESC Exit ←→ Select Menu Enter Select Sub-Menu F10 Previous Values

Exit