Specifications

EPC-8A Hardware Reference
66
EXP-BP2 Subplane
Figure E-2. EXP-BP2 Subplane
This subplane is to provide connectivity for
the processor and two EXM modules.
The EXP-BP2 is an L-shaped board with
three connectors on each side.
After jumpering the backplane, plug the
subplane into the VMEbus backplane such
that the P2 connector on the back of the
4-row DIN is pressed into the J2 connector
of the left-most VMEbus slot that the
EPC-8A subsystem will occupy.
The lower EXM EXM connector is denoted
as EXM slot 0 and the upper as slot 1 as
shown in the diagram. This information is
needed later when configuring the installed
EXMs.
Insert EPC-8A in these two slots