Owner's manual

Programming The Memory Feature

NOTE: To create a new memory profile, perform the

following:

Vehicles Equipped With Keyless Enter-N-Go

1. Without pressing the brake pedal, push the ENGINE

START/STOP button and cycle the ignition to the

ON/RUN position (Do not start the engine).

2. Adjust all memory profile settings to desired prefer-

ences (seat, side mirrors, adjustable pedals and radio

station presets).

3. Press and release the S (Set) button on the memory

switch.

4. Within five seconds, press and release either of the

memory buttons (1) or (2). The Electronic Vehicle

Information Center (EVIC) will display which

memory position has been set.

Vehicles Not Equipped With Keyless Enter-N-Go

1. Insert the ignition key fob, and turn the ignition switch

to the ON/RUN position.

2. Adjust all memory profile settings to desired prefer-

ences (seat, side mirrors, adjustable pedals [if

equipped], power tilt and telescopic steering column