Owner's manual

WARNING!

Sudden loss of visibility through the windshield

could lead to a collision. You might not see other

vehicles or other obstacles. To avoid sudden icing of

the windshield during freezing weather, warm the

windshield with the defroster before and during

windshield washer use.

Mist Feature

When a single wipe to clear off road mist or spray from

a passing vehicle is needed, push the washer knob,

located on the end of the multifunction lever, inward to

the first detent and release. The wipers will cycle one

time and automatically shut off.

NOTE: The mist feature does not activate the washer

pump; therefore, no washer fluid will be sprayed on the

windshield. The wash function must be used in order to

spray the windshield with washer fluid.

Rain Sensing Wipers — If Equipped

This feature senses moisture on the windshield and

automatically activates the wipers for the driver. The

feature is especially useful for road splash or overspray

from the windshield washers of the vehicle ahead. Rotate

the end of the multifunction lever to one of five settings

to activate this feature.

The sensitivity of the system can be adjusted with the

multifunction lever. Wiper delay position 1 is the least

sensitive, and wiper delay position 4 is the most sensi-

tive. Setting 3 should be used for normal rain conditions.

Settings 1 and 2 can be used if the driver desires less

wiper sensitivity. Setting 4 can be used if the driver

desires more sensitivity. Place the wiper switch in the

OFF position when not using the system.

NOTE:

• The Rain Sensing feature will not operate when the

wiper switch is in the low or high-speed position.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 173