Owner's manual

3. Simultaneously press and hold both the Homelink®

button while you press and release (“cycle”), your

hand-held transmitter every two seconds.

4. Continue to hold buttons until the EVIC display

changes from “CHANNEL # TRAINING” to “CHAN-

NEL # TRAINED”, then release both buttons.

NOTE:

• It may take up to 30 seconds or longer in some cases

for the channel to train.

• If the EVIC displays “DID NOT TRAIN” repeat from

Step 2.

5. Press and hold the programmed HomeLink® button.

The EVIC will display “CHANNEL # TRANSMIT”. If

the device is plugged in and activates, programming is

complete.

If you unplugged the garage door opener/device for

programming, plug it back in at this time.

Reprogramming A Single HomeLink® Button

To reprogram a channel that has been previously trained,

follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLink® button until

the EVIC displays “CHANNEL # TRAINING” Do not

release the button.

3. Without releasing the button proceed with

“Canadian/Gate Operator Programming” Step 2 and

follow all remaining steps.

Using HomeLink®

To operate, press and release the programmed

HomeLink® button. Activation will now occur for the

programmed device (i.e., garage door opener, gate opera-

tor, security system, entry door lock, home/office light-

ing, etc.,). The hand-held transmitter of the device may

also be used at any time.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 201