Owner's manual

Remote Key Unlock, Driver Door/All Doors First

This feature lets you program the system to unlock either

the driver’s door or all doors on the first press of the

UNLOCK button on the RKE transmitter. To change the

current setting, proceed as follows:

• For vehicles equipped with the EVIC, refer to “Elec-

tronic Vehicle Information Center (EVIC)/Customer-

Programmable Features (System Setup)” in “Under-

standing Your Instrument Panel” for further

information.

• For vehicles not equipped with the EVIC, perform the

following procedure:

1. Press and hold the LOCK button on a programmed

RKE transmitter for at least four seconds, but no

longer than ten seconds. Then, press and hold the

UNLOCK button while still holding the LOCK button.

2. Release both buttons at the same time.

3. Test the feature while outside of the vehicle by press-

ing the LOCK/UNLOCK buttons on the RKE trans-

mitter with the ignition switch in the OFF position and

the key removed.

4. Repeat these steps if you want to return this feature to

its previous setting.

NOTE: Pressing the LOCK button on the RKE transmit-

ter while you are inside the vehicle will activate the

Vehicle Security Alarm System. Opening a door with the

Vehicle Security Alarm System activated will cause the

alarm to sound. Press the UNLOCK button to deactivate

the Vehicle Security Alarm System.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 25