Owner's manual

• For security, power window and power sunroof op-

eration (if equipped) are disabled when the vehicle is

in the Remote Start mode.

• The engine can be started two consecutive times (two

15-minute cycles) with the RKE transmitter. However,

the ignition switch must be cycled to the ON/RUN

position before you can repeat the start sequence for a

third cycle.

To Exit Remote Start Mode Without Driving The

Vehicle

Press and release the REMOTE START button one time or

allow the engine to run for the entire 15-minute cycle.

NOTE: To avoid unintentional shut downs, the system

will disable the one time press of the REMOTE START

button for two seconds after receiving a valid Remote

Start request.

To Exit Remote Start Mode And Drive The Vehicle

Before the end of the 15-minute cycle, press and release

the UNLOCK button on the RKE transmitter to unlock

the doors and disarm the Vehicle Security Alarm System

(if equipped). Then, prior to the end of the 15 minute

cycle, press and release the START/STOP button.

NOTE:

• The message “Push Start Button” will display in the

EVIC until you push the START button.

• “Remote Start Active — Push Start Button” will dis-

play in the EVIC until you press the start button. Refer

to “Electronic Vehicle Information Center (EVIC)” for

further information.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 33