Owner's manual

Tire Pressure Information label. The Supplemental Tire
Pressure Information label is located on the rear face of
the driver door opening. Use an accurate tire gauge to
check the tire pressures when lowering all four tire
pressures. The vehicle may need to be driven above
15 mph (25 km/h) to receive this updated pressure
information. After all four tire pressures have been
lowered to the Light Load inflation pressures, press the
tire light load inflation switch. If the tire light load
inflation switch’s amber colored LED turns ON, the
TPMS is using the light load inflation pressure (cold) low
pressure warning thresholds. A text message ⬙Tire Pres-
sure System - Light Load Setting⬙ will also be displayed
in the EVIC.
If the tire light load inflation switch amber colored LED
flashes on and off for 10 seconds, after all four tire
pressures have been lowered to the Light Load inflation
pressures, the pressure in any one of the four tires may
not be at the light load inflation pressure (cold) values as
indicated for the Light Load condition as defined on the
Supplemental Tire Pressure Information label located on
the rear face of the driver door. A text message ⬙Cannot
Enter Light Load Setting - Please Adjust Tire Pressure⬙
text message will also be displayed in the EVIC. Using an
accurate tire pressure gauge, re-check the tire pressures
for the light load inflation pressure (cold) value.
WARNING!
It is the driver’s responsibility to change to the max load
inflation pressure (cold) low pressure warning threshold
condition when not driving in the light load condition as
defined as two occupants (150 lbs [68 kg] each) plus 200
pounds (91 kg) of cargo. The vehicle “Light Load Defi-
nition” is found in the Supplemental Tire Pressure
Information label located on the rear face of the driver
door. Failure to do so may cause you to lose control
resulting in an accident, causing serious or fatal injury.
5
STARTING AND OPERATING 521