Owner's manual

Connect the jack tube extension and wheel wrench.

CAUTION!

Before raising the wheel off the ground, make sure

that the jack will not damage surrounding truck parts

and adjust the jack position as required.

NOTE: If the bottle jack will not lower by turning the

dial (thumbwheel) by hand, it may be necessary to use

the jack drive tube in order to lower the jack.

4. By rotating the wheel wrench clockwise, raise the

vehicle until the wheel just clears the surface.

WARNING!

Raising the vehicle higher than necessary can make

the vehicle unstable and cause a collision. It could

slip off the jack and hurt someone near it. Raise the

vehicle only enough to remove the tire.

5. Remove the wheel nuts and pull the wheel off. On

single rear-wheel (SRW) trucks, install the spare wheel

and wheel nuts with the cone shaped end of the wheel

nuts toward the wheel. On 3500 dual rear-wheel

models (DRW) the wheel nuts are a two-piece assem-

bly with a flat face. Lightly tighten the wheel nuts. To

Rear Jacking Location (All)

WHAT TO DO IN EMERGENCIES 605