User`s guide

Rand McNally IntelliRoute

TND

510 User’s Guide Version 2.0.1 10

Install the Cradle and Mount

Select an area with a line of sight to the sky and GPS satellites to ensure reliable

GPS information.

Note:

Obey all local regulations governing the placement of the mount.

Note:

Do not place the mount in an airbag deployment area.

1. Clean and dry the mounting area.

2. Remove the suction cup protective  lm.

3. Adjust the angle of the mount using the thumbscrew and slide the mount

onto the cradle.

4. Pull the suction cup lever up to release suction.

5. Place and hold the mount suction cup against the mounting surface.

6. Press the suction cup lever down until it snaps into place.

7. Angle the bottom of the device into the cradle and align the two slots on the

bottom of the device into the two projections on the cradle.

8. Press the top of the device towards the cradle until you hear the upper clip

latch into place.

9. Plug the power cord into the device and the vehicle’s 12 volt power source.

10. Adjust the navigation device so that it can be easily seen and does not block

the driver’s line of sight.