User`s guide

Rand McNally IntelliRoute
®
TND
TM
510 User’s Guide Version 2.0.1 50
Near End of Day Location
Note: This feature uses your remaining hours of service and average speed to
estimate your end of day location. The device then searches for the selected POI
category around the estimated location. To use this feature, driver timers must
be properly used. See “Timers and Logs” on page 95.
1. Create a route or load a trip.
From the Main Menu:
2. Tap Choose Destination > Points of Interest > End of Day.
The POI Category Window displays.
3. Tap:
• Travel Center and  lter for amenities. (See page 43.)
• Truck Service and  lter for services. (See page 44.)
• Parking & Rest Area, Weigh Station, CAT Scale, or Truck Dealer.
• More and select a Consumer POI. See page 45 and page 46.
The Select <Point of Interest Type> Window displays POI locations.
Note: If no locations are found, a message displays.
4. Tap on a location on the list.
The Con rmation Window displays:
5. Tap Begin New Route to navigate to the location.
See “Address Con rmation Window” on page 72 for more options.
6. If the vehicle mode is set to Truck and the Load Option is set to Prompt, a
Con rmation Window asked if the Truck is empty or loaded.
7. Tap the appropriate truck load option to create the route.
POI Category Window
Select <Point of Interest Type> Window