User's Manual

Road Explorer
™
50 & 60 User Manual
2
1. Your Device
What’s Included
• Rand McNally Road Explorer
™
• Windshield mount with suction cup
• Quick Start Guide
• Vehicle charger
• USB cable
Charge the Battery
It is recommended that the device is always
connected to a power source during use.
Note: The vehicle may need to be on for the device to charge.
Install the Mount
Note: Follow all local regulations governing the placement of the mount.
1. Select an area with a line of sight to the sky and GPS satellites.
2. Clean and dry the mounting area.
3. Remove the suction cup protective fi lm.
4. Adjust the angle of the mount using the thumbscrews.
5. Pull the suction cup lever up to release suction.
6. Plug the power cord into the device and the vehicle’s 12-volt
power source.
7. Clip the device onto the mount.
8. Place and hold the mount suction cup against the
mounting surface.
9. Press the suction cup lever down until it snaps into place.
10. Adjust the device so that it can be easily seen and does not
block the driver’s line of sight.
Press down
to hold
Press down
to hold
Clip in
to mount
Clip in
to mount
Thumbscrew
Thumbscrew
Road Explorer
™
60 Road Explorer
™
50