Owner manual

Aerobell Copes - Maintenance
20
Figure 9: Replacement Elements
Part#
HAF-15
RPM-32
RPM-33
1
4
8
HAF-503, Pre-Filter
RPM-417, Pre-Filter
RPM-418, Bearing Air
Filter
Qty. Elements
Per Carton
Used On
• Verify that high voltage is OFF, turbine drive air is
OFF, and that the bell cup has stopped spinning. The
bearing air and shaping air should remain ON.
• Clean all external surfaces of the applicator using a
lint-free rag dampened with solvent. External surfaces
include the quick-change applicator, retaining nut,
rear manifold, and electrodes.
• After cleaning, all conductive residue must be
removed using a non-conductive solvent. Since
electrostatic equipment is involved, these solvents
should also be non-polar.
Weekly Maintenance
• Follow all procedures as described under daily
maintenance prior to performing any weekly
maintenance.
• Verify that shaping air is OFF, remove the shaping
air ring and cap from the applicator for thorough
cleaning.
• Clean the shroud edge, which mates with the
shaping air ring taper, using a lint-free rag dampened
with solvent.
• Clean the shaping air ring taper, which mates with
the shroud edge, using a soft bristle brush dipped in
solvent.
• Clean all external surfaces of the air ring and cap
using a lint-free rag dampened with solvent.
• Remove the cap for cleaning inside surfaces. The
parts may be soaked in clean solvent only, to loosen
paint that has wicked around the cap.
• After removing the cap, use a soft bristle brush
dipped in solvent to clean the grooves, male threads
of the air ring, and female threads of the cap.
• Paint residue found in the shaping air or exhaust
holes is not acceptable and must be removed prior
to assembly.
• After cleaning, all conductive residue must be
removed using a non-conductive solvent. Since
electrostatic equipment is involved, these solvents
should also be non-polar.
MEAN TIME BETWEEN FAILURE
Air Filters / Element Replacement
Ransburg Aerobell Copes systems include a pre-
lter(s) and a nal lter for all air to the Aerobell
Copes unit. The nal lter is for bearing air only.
All lters contain elements that must be replaced
on a regular basis to assure clean air. RPM-417 and
RPM-418 lters also contain an automatic drain and
pressure dierential indicator.
LN-9230-00.1
> The high voltage must be turned OFF
before entering the spray area and performing
any maintenance procedures. Spray booth ex-
haust fan(s) should remain ON while cleaning
the equipment with solvents.
W A R N I N G
!
> Introducing air which contains oil, mois-
ture and dirt may cause wear and damage to
the bearings. It is the user’s responsibility to
monitor the quality of air and to replace the
lter elements as often as necessary. Turbine
failure caused by poor air quality will not be
covered under warranty.
C A U T I O N
!