Owner manual

Quick Change Aerobell
Motor Disassembly
1. Remove 76757-00, shaping air ring cap,
76756-00, shaping air ring from the shroud
and the atomizer bell from the turbine shaft
(refer to “Atomizer Bell Removal” on page
22.)
2. Remove shroud by removing the three 76748-
12F, llister head screw, using medium at
head screwdriver. Shroud can then be pulled
forward.
Aerobell Copes Turbine
Disassembly & Repair
Disassembly and repair of the Turbine is covered in
Service Reference SR-70-52-1 (latest issue). When
returning the air bearing turbine to Ransburg for
repair, return the Quick Change Motor Assembly or
turbine only.
Copes Quick Change Aerobell
Motor Reassembly
1. Reassemble the shroud, atomizer bell,
shaping air ring and cap onto the Quick
Change Motor Assembly by reversing the
above instructions.
2. Before installing the Quick Change Assembly
back into the manifold, check the condition
of the four-coated o-rings located on the
four air ttings of the manifold. If any are
damaged or missing, replace them.
Aerobell Copes - Maintenance
23
AEROBELL COPES TURBINE
MAINTENANCE & REPAIR ITEMS
Figure 10: Pre-packaged Repair Kits
Kit Part No.
KK-4461
KK-4462
KK-4463
RPM-33
RPM-32
Description
Turbine Repair Kit
(for on-site turbine repair)
Rotor Screw Kit
(for on-site turbine repair)
Turbine Screw Kit
(for on-site turbine repair)
Bearing Air Filter Element Kit
(box of 8)
Pre-lter Element Kit
(box of 4)
3. Check the condition of the SSG-8128, o-ring,
located on the uid inlet on the rear of the
turbine. Replace if damaged or missing.
Lightly lubricate the SSG-8128, o-ring, with
petroleum jelly.
4. Install the Quick Change Motor Assembly
onto the manifold. Align properly (it is
easiest to align the shaping air tting which
is furthest from the center line). Press the
Quick Change Assembly straight forward as
much as possible (don’t force it on).
5. Tighten 75844-00, retaining nut, CW which
will draw the quick change motor assembly
fully into place with the manifold.
LN-9230-00.1
> Disassembly and repair of the turbine dur-
ing warranty period is not allowed. See “War-
ranty” on page 32, and refer to SR-70-52-1 for
details.
C A U T I O N
!