Network Router User Manual

28 DOMINION KX USER GUIDE
 Click OK to accept the Access Control List changes or Cancel to close the window
without saving changes.
Important: Please note that ACL rules are evaluated in the order in which they
are listed. For instance, if in the above example, the two ACL rules were
reversed, Dominion KX101 would accept no communication at all. Use the
buttons on the right of the window to adjust the order of your list.
− Enable automatic failover: (Dominion KX only) Click on this check box to allow
Dominion KX to automatically recover its network connection using a second network
port if the active network port fails. Ping interval determines how often Dominion KX
will check the status of the network connection (setting this too low may cause excess
network traffic). Timeout determines how long a network port must be “dead” before the
switch is made. Both network ports must be connected to the network and this option
must be checked for Automatic Failover to function. Default Ping interval: 30 seconds;
default Timeout: 60 second.
Note: The default Ping interval and Timeout generate a condition that when the KX device tries
to switch over, any remote sessions will be dropped. Users must re-establish the session.
Reducing these intervals to much lower values will allow remote sessions to stay connected but
will result in increased network traffic.
2. Click OK to set Network Configurations or click Cancel to close the window without saving
changes.
3. If your changes require rebooting the device, a reboot message appears.