Network Router User Manual

CHAPTER 3: ADMINISTRATIVE FUNCTIONS 53
Power Control (Dominion KX only)
The Dominion KX supports up to eight (8) power strips. Users may group or assign up to four
outlets to any of the Dominion channels. Once assigned, the power management function is
available in MPC and RRC.
Setup Preparation
You must have a power strip and the P2CIM-PWR Computer Interface Module (CIM). The CIM
is included with the power strip shipment; however, if you need a replacement CIM, you can
purchase a P2CIM-PWR from Raritan Computer, Inc. or an authorized Raritan reseller.
Connecting the Power Strip
1. Connect the male RJ-45 of the P2CIM-PWR to the female RJ-45 connector on the power
strip.
2. Connect the female RJ-45 connector of the P2CIM-PWR to any of the available female
system port connectors on the Dominion KX using a straight through Cat 5 cable.
3. Power ON the power strip.
4. Power ON the Dominion KX unit.
Configuring the Power Strip
1. Once the power strip has been added, KX Manager will automatically recognize that a power
device is connected. The Device Tree in the left panel of the window will change the
appropriate target icon to indicate that a power strip is connected to that port.
2. Select the power strip icon, right-click on it, and click Properties. When the Power Strip
Properties screen appears, type a name for the new power strip and click OK.
3. In the Devices Tree, select the target server(s) powered through the power strip. Right-click
on the server icon and click Properties. The PC Properties window appears.
Figure 39 Associating a Target with a Power Outlet
4. Click on one of the Power Strip cells in the table and a list of available power strips
connected to the Dominion KX appears. Click on the appropriate power strip.
5. Click on the Outlet cell in the same row as the power strip selected. A list of available outlets
appears; select the outlet to which the device is connected.
6. Repeat these steps for all devices plugged into multiple outlets.