Sky Totter™ Owner’s Manual www.ravesports.com Copyright © All rights reserved. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, without permission in writing from the publisher. Requests should be mailed to RAVE Sports, 3325 Labore Rd., St. Paul, MN 55110.
Instructions & Warnings For Proper Use of RAVE Inflatable Products • Inflation, set up and supervision must be done by a mature and knowledgeable adult! • Inspect product for any unsafe conditions before use! Do not use if repair is needed! • Instruct children on proper use of this product. • Over-inflation is the major cause of leaks. Do not inflate with an air compressor or other high pressure pump. • Read the instructions and warnings printed in this manual for proper inflation and safe use.
Table of Contents Sky Totter.......................................................................................................................... 3 Inflation ............................................................................................................................ 4 Deflation ......................................................................................................................... 7 Anchoring...............................................................................
Sky Totter INFLATION: any of the recommended types of inflators. Foot / Hand pumps are not recommended for the main chamber due to the size of the product. PARTS: 1 – Inflatable Sky Totter 1 – Owner’s manual 1 - Repair Kit consisting of: 4 oz of Glue, 2 – 8” square patch of each in White and Blue. POSITION: Make sure water depth is a minimum of 8 feet deep. There should also be a minimum of 16 feet clearance all around the unit. RECOMMENDED MAXIMUM WEIGHT: 1,500 LBS. RECOMMENDED NO.
INFLATION SET UP AND SUPERVISION MUST BE DONE BY A MATURE AND KNOWLEDGEABLE ADULT! You can use the following devices to inflate the Product: • Electric Inflator/Deflator (household current). RAVE recommends the High Speed Inflator/Deflator, item #01083. CAUTION: Use extreme care when using an electric inflator anywhere near water. Beware of the dangers of electrocution when using electric powered inflators. Precautions should be observed during use and handling to prevent shock.
OPEN CLOSE Halkey Roberts Valve – To lock open valve, depress the stem and rotate ¼ turn clockwise. To close valve, depress the stem and rotate ¼ turn counter-clockwise. The valve stem should be in the depressed position while inflating. Replace the cap on valve after inflation to ensure air tight seal. A special inflation adaptor is included with this product.
DO NOT OVER-INFLATE!! Product should not be firm! There should be a depression when pushed on with your hand. Please Note: Keep in mind the temperature of the air going into the product and the outside air. If your inflator is hot and sending warm air into the product, when it cools, it will seem like your Product is losing air. This is normal. Weather and temperature variations will also cause the air inside the unit to expand and condense. This is normal.
DEFLATION PRIOR TO DEFLATION, REMOVE ALL CHILDREN FROM THE UNIT! Use one of the Inflator/Deflator devices recommended in the “Inflation” Section for faster deflation. Halkey Roberts Valve - Unscrew the cap by twisting counterclockwise to expose the air valve stem. Open the air valve by pushing in the stem and rotating clockwise. Allow air to escape. Pushing on the stem and rotating counterclockwise will seal the valve. Replace cap making sure it is tightened securely. Completely Dry Unit.
• Nylon rope holds up the best in water and sun. Lines do eventually wear out, so it’s important to check them periodically. • Choose a location that is most protected from the wind, of sufficient water depth and free of obstructions a safe distance in all directions. • A minimum of 150-200 lbs. of anchor weight per anchor point is recommended for most applications; however, larger products on larger bodies of water may require more.
Anchoring a stainless steel snap hook to the buoy simplifies the process of removing your product from the water for cleaning or repair. It also makes it simple to return your product to its previous location. Forsheda MAINTENANCE Maintenance is essential to increase the life of your product. Please follow all maintenance and repairs according to this manual. If you are unsure please contact your local dealer, service center or RAVE Sports directly.
Always remove your inflatable from the water when not in use. To extend the life of your inflatable – keep out of sunlight when not in use. For additional protection, we recommend using U.V. protectant. CLEANING If your inflatable is used intensively, then it should be cleaned on a weekly basis. It is also important to clean and dry the product before it is packed away. When cleaning your product never use strong detergents or siliconebased products.
STORAGE When storing your inflatable, keep it in a clean and dry place that is not affected by major variations in temperatures and other damaging factors. You can store your inflatable deflated and rolled up or lightly inflated. Be careful never to stack anything on top of inflatable. It is recommended that you allow the unit to completely dry before storage. It is recommended to lubricate the rubber on the valves with a petroleum based product to increase the life of the valve.
Step 2 – Cut out a patch approximately 2 inches larger than the leak. Clean the damaged part of the product and patch and allow to dry thoroughly. TIP – It is a good idea to always use a circle or rectangle patch with rounded corners. Pointed corners tend to pull off. Step 3 – Next clean the area and the patch with alcohol, grease remover, or fingernail polish remover and allow to dry thoroughly. Step 4 - Apply glue in a very thin layer to the patch and then to the area of the leak.
TIP – It is a good idea to check again for leaks. If you have multiple leaks, the air will rush out of a larger hole before a smaller one. CAUTION: When using glue, remove unused glue from threads of tube and cap and carefully replace the cap on the tube. If properly sealed it will keep perfectly. Do not leave the tube in the sun or next to heat sources or direct flames. • Check that the room is properly ventilated, avoid inhaling or ingesting the glue and avoid contact with skin.
! WARNING • THIS IS NOT A LIFESAVING OR PERSONAL FLOTATION DEVICE. DO NOT LEAVE CHILD UNATTENDED WHILE IN USE! • ALWAYS USE A U.S. COAST GUARD APPROVED (PERSONAL FLOATATION DEVICE) VEST FOR CHILDREN AND ADULTS! • ALWAYS ANCHOR THE INFLATABLE SECURELY BEFORE USE! • ALWAYS INSPECT AREA FOR RECOMMENDED WATER DEPTH BEFORE USE! • ALWAYS KEEP A MINIMUM OF 16 FEET (4.
www.ravesports.com RAVE Sports A Revel Match, LLC Company 3325 Labore Road Saint Paul, Minnesota 55110 800.659.
