Owners manual

S37 Light

Tells the display to control the system Backlighting or just its

own Backlighting.

The options are: Network/Local.

S38 LCD Contrast

Allows the contrast of the LCD display to be adjusted to suit

the viewing angle of the display. The lower the figure the less

contrast is visible.

The available options are: 1 - 7 default 4.

S39 Boat Show

Allows the display to show information when NOT installed

as part of a Micronet system for demonstration purposes

only.

Displays will return to default Off on power down.

S40 Factory Reset

Returns all the calibration setting to the factory default values

but does not reset your Auto Networking.

Only carry out a Reset after consulting with an authorized

Raymarine dealer.

SETUP HELTH - Health Chapter

S41 Software Version/Network Nodes

The upper window shows the display’s Software Version.

The lower window shows battery level and charge rate, by

means of the appropriate icons, to assist in troubleshooting

and fault finding.

If the display is the "Master" (the one used to switch on the

system) then the number of items (nodes) in the system will be

displayed in the lower window. If the display is a "Slave" (was switched

on by the system) then the signal strength to the "Master" will be shown.

Set-up and Calibration