Owners manual

2.2 Switching the System On and Off
To switch your Micronet system on or off select any display and press
the button for 2 seconds.
2.3 Backlighting
At any stage of the display’s operation press and hold for 2
seconds the button to access the lighting control.
Pressing the and buttons will scroll through setting
OFF, 1, 2 and 3 whilst changing the Backlighting.
Depending on the display setup (see page 27 -s37),
Backlighting on the whole system or just the single display will be
altered.
Backlighting is automatically switched off in daylight as part of the
display’s power saving feature and will not operate in daylight.
2.4 Audible Signals and Alarms
At stages during its operation your Micronet display will beep to indicate
alarms or moments of importance.
Power-up Once operating as part of a network the display will issue a single
beep as it is switched on by pressing the button for 2
second.
Button Press A single beep is issued each time a button is pressed. A second
beep is issued after a 2 second hold down of the button.
Timer A single beep will be issued at each minute of the countdown.
With 1 minute left to go a beep will sound every 10 seconds. With
10 seconds to go a beep will sound every second.
Countdown complete will be indicated by a single burst of three
beeps.
mn100 Dual Digital Display
6
www.raymarine.com
Switch on
Switch off