user manual

The parameters are defined as follows:

Modbus Slave Address: Each of the separate drop offs of a Modbus

host must have a different slave address. The slave address is

selected by encoding the slave address in a binary form using the

dip switches.

11.3.1.3 T-3 Jumper Configurations

The T-3 card has five sets of jumpers on the board. Generally, the

default jumper positions will be adequate for most applications, with

JP4 and JP5 being the only jumpers that should ever need to be

reviewed. For completeness, we provide the following discussion on

all the jumper locations:

Jumper Description Positioning Default

JP1 Hardware Reset Not Used

JP2 Raypak Port 1-2 Non-Isolated Power 1-2

Power (P2) 2-3 Isolated Power

JP3 Raypak Port 1-2 Non-Isolated Power 1-2

Ground (P2) 2-3 Isolated Power

JP4 Modbus Port (P1) 1-2 Connect 120 ohms on 2-3

Termination Rx lines (multidrop only)

Resistor 2-3 Disconnect 120 ohms

JP5 Modbus Port (P1) 1-2 RS-232 Select 2-3

RS-232 or 2-3 RS-422/485 Select

RS-422/485 Select

11.3.2 B6000 Communications

The B6000 communications interface has been hard coded (i.e., no dip switches

are required to configure this port) to operate at the following default conditions:

Baud 9600

Parity None

Stop Bits 2

The T-3 card emulates the modem card that is normally connected to the

B6000 Controller.