user manual

T-3 (Raypak B6000 System Protocol Interface)

Contents Quantity

COMPACT DISC (CD) 1

T-3 1

EPROM (CPX.XNMn) in small black ESD box 1

Check packaging for damage or missing components.

IMPORTANT NOTICE: These instructions are intended for the use by qualified personnel only,

specifically trained and experienced in the installation of this type of equipment and related sys-

tem components. Installation and service personnel may be required by some states to be

licensed. If your state is such, be sure your contractor bears the appropriate license. Only quali-

fied persons shall attempt to repair this equipment. Repair must be according to these instruc-

tions.

WARNING: Improper installation, adjustment, alteration, service or maintenance may damage

the equipment, create a hazard resulting in asphyxiation, explosion, fire, electric shock, personal

injury or property damage and will void the warranty.

CAUTION: ONE SUPPLY SOURCE. TO REDUCE THE RISK OF ELECTRIC SHOCK,

DISCONNECT ALL CONNECTIONS BEFORE SERVICING.

CAUTION: RISK OF ELECTRIC SHOCK, DISCONNECT SWITCH IS REQUIRED TO DE-

ENERGIZE THE EQUIPMENT BEFORE SERVICING.

NOTE: Minimum 18 AWG, 105°C, stranded wire must be used for all low voltage (less than 30

volts) external connections to the unit. Solid conductors should not be used because they can

cause excessive tension on contact points. Install conduit as appropriate. All high voltage

wires must be the same size (105°C, stranded wire) as the ones on the unit or larger.

Thank you for selecting the Raypak B6000 Boiler Management System and the Raypak

Communication Interface. It is our sincere hope that you will enjoy its power, ease of use and

energy saving features.

Please follow the instructions carefully to insure proper installation.

FORWARD

The Raypak Communication Interface is designed to allow the Communication Interface System

to monitor and control the Raypak B6000 Boiler Management System.