User Manual

37
NOTE: Your unit will record a message up to the maximum length of time
you set as long as the caller continues speaking. To save recording capacity,
your unit will automatically stop recording after 7 seconds of silence or if
there is a steady dial tone for 7 seconds.
The maximum recording time for each incoming message can be set in Menu.
Monitoring Incoming Calls
Whenever an incoming message is being recorded you can hear it through
the speaker if Call Screening is On. To take the call, press Line button on
base or Line softkey on handset and the system stops recording.
Memo Record (Only applicable for base)
You can leave a message by pressing the Memo button on base .
1. Press the Memo button on base to enter memo record mode.
2. Press Line1 or Line2 softkey to select the mailbox to save the recording.
3. “Record memo after beep” shows in the display.
4. After the beep, begin speaking and “Recording” shows in the display.
5. Press the FINISH soft key to end the recording.
NOTE: The maximum duration allowed for memo is the same as the message
length setting in the menu.
Memo Recording (Only applicable for Handset)
From the Main Menu by press Menu button on the Handset.
1. Press the VOL (- or +) button to scroll to Memo recording.
2. Use VOL (- or +) button to select Line1 or Line2 to save the recording.
3. Press SELECT soft key to confirm. “Record memo after beep” shows in
the display.
4. After the beep, begin speaking and “Recording” shows in the display.
5. Press the FINISH soft key to end the recording.
Message/Memo Playback
In idle mode, press base Ans Sys button when flashing or press Play button
on handset or on base. The unit enters the message playback mode, and the
status of messages for each line display. Use VOL(- or +) can select Line 1
and Line 2, press SELECT soft key to play the messages.
If the unit has new messages, only the new messages will be played,
otherwise all messages will be played. Unit will play messages to the end.
Answering System Operation