Manual

ABOUT PROGRAMMING THE REMOTE
The remote can be programmed to control other brands or
remote controllable TVs, digital satellite receivers, and cable
boxes. It is already programmed to operate most RCA, GE, and
ProScan televisions and digital satellite receivers.
PROGRAMMING THE REMOTE TO
CONTROL A TV
If the TV does not turn on when you press the TV button, the
remote needs to be programmed.
Follow these steps to program the remote to control your
particular TV:
1. Turn on theTV.
2. Find your TV brand and code number(s) on the code _ist on
the next page.
3. Press and hold the TV button on the remote.
4. Enter the code from the code list.
S.
6,
Release TV, and then press CHAN up or down. If the TV
responds to the remote commands, the remote is
programmed.
If the TV does not respond, repeat these steps using the next
code listed for your "l'V's brand
OPERATING THE TV
After you set up the remote, see which buttons operate your TV.
1. Point the remote at the TV, and press the IV button..
If the TV does not turn on, press the TV button and then
press the PWR button.
2. You may want to experiment to see which buttons operate
your TV. Try pressing buttons, such as VOL and MUTE. See
"TV Function Buttons" in the VCR Basics Section for details.
36
This remote may not operate all
models of the brands that are
shown.
Note the difference between the TV
and VCR on-screen displays to see
which one the remote isoperating.