Manual

TRACKING
Your VCR has automatic tracking which removes the streaks
or snow from the picture. Automatic tracking is activated
when you insert a tape or turn on the VCR. Occasionally you
may need to manually adjust tracking, especially if the tape
was recorded on a different VCR. Just use the TRACK buttons
to remove the streaks or snow. You can also use tracking
when you pause a tape to reduce jittering of the picture.
When you manually adjust the picture, automatic tracking is
turned off. To turn automatic tracking back on, press both
TRACK buttons on the front of the VCR at the same time, or
eject the tape and re-insert it. Tracking has no effect during
recording-_only playback.
TIME COUNTER
The time counter shows the actual time it takes to record a
program or play back a segment of a recorded tape. It helps
locate the beginning or end of programs you taped. The time
counter resets to 0:00:00 whenever the tape is ejected from
the VCR.
For example, if you record a 30-minute program at the
beginning of the tape and you want to go to the end of that
program to begin another recording, you would:
1. Press INFO twice to display the time counter.
2. Press CLEAR to reset the time counter to 0:00:00.
3. Press FWD to forward the tape until the time counter
reads 0:30:00.
4.
5.
Press STOR This is the approximate end of the program.
(You may want to press PLAY to verify.) Now, you can
begin recording at this spot.
Press INFO twice to remove the time counter from the
screen and return to the normal display mode.
Hours Minutes
"0:30:00 I
"" Seconds
43