User Manual

7
ENGLISH
[1] MIC INPUTS
RCF F 10XR provides 4 mono Mic inputs via XLR connectors (Ch. 1 to 4). The Balanced XLR Microphone
preamp input provides a gain range from 0 dB to -50 dB. All the F 10XR’s MIC-LINE inputs are supplied
with an 80 Hz Hi-pass filter. Enable the 80 Hz Hi-Pass filter when using voice microphone to reduce low
frequency pop, bump and rumble noises (see section [10] and [11] of this manual). +48 V Phantom
Power is provided for the Mic input 1 to 4. Enable the Phantom power in presence of condenser and
electret microphones or in the event of D.I. box usage (see section [16] of this manual).
[2] LINE INPUTS
Line inputs TRS jack 1 and 2 provide a gain of +20 dB to -30 dB to line sources.
[3] STEREO INPUTS 3/4 AND 5/6
TRS jacks 3/4 and 5/6 provide stereo inputs for line sources. Note that MONO sources can be connected
to jack inputs 3 and 5.
[4] STEREO INPUTS 7/8 AND 9/10
RCA and TRS jacks 7/8 and 9/10 provide stereo inputs for line sources. Note that MONO sources can
be connected to jack inputs 7 and 9.
[5] MAIN OUTPUTS
These XLR male connectors provide +4 dB balanced audio output coming from MAIN MIX. Connect
your main speaker system to XLRs, named L and R. The audio level of MAIN MIX OUT L and R is
controlled by the dedicated MAIN MIX rotary knob (see section [31] of this manual). L and R XLR MAIN
MIX outputs are replicated with L and R TRS jack.
[6] CTRL ROOM OUTPUT
Connect to the Control Room Output Balanced jacks a pair of studio monitors as a local listening
system. The audio level of the CTRL ROOM output is controlled by the dedicated CONTROL ROOM
potentiometer on the front panel (see section [20] of this manual).
[7] FOOTSWITCH
This TS jack connector allows the use of MOMENTARY switches or foot pedals to MUTE and UN-MUTE
the audio coming from the internal FX return. When the FX is muted via footswitch the red LED near the
FX MUTE button lights up (see the section [28] of this manual). In this state, the effect can be unmuted
either by pressing the FX MUTE button or the FOOTSWITCH again.
[8] AUX/FX OUTPUT
This TRS jack connector provides +4 dB balanced audio output from the auxiliary send. Connect your
stage monitor or external effects input here (see the section [21] of this manual).
[9] PHONES OUTPUT
Connect headphones here to listen to the MAIN MIX. To avoid hearing loss, set the PHONES LEVEL
control to minimum (-∞) before connection and wear headphones (see section [24]).
FRONT PANEL FUNCTIONS