User`s manual

W
A
T
E
R
P
U
L
L
O
P
E
N
Rolling
Divider 10EA
<sold separately>
Rolling
Divider 10EA
<sold separately>
DIGITAL󰚟INCUBATOR
11
1
10
V~
12
0V
W
A
T
E
R
P
U
L
L
O
P
E
N
W
A
T
E
R
P
U
L
L
O
P
E
N
W
A
T
E
R
P
U
L
L
O
P
E
N
Insert the electric cord in the connecting jack
in the back of the main body and put the main plug into a
socket. The LCD display will light up and show temperature.
After filling up with water, never shake or turn over
the main body of the incubator, which would cause water
to spill inside the body and could cause a breakdown.
Be careful to close the view window completely;
if not, the temperature and humidity will fail to go up.
Place the eggs to incubate in the egg groove and then close
the view window.
1
Open the watercap and fill the hole with clean water and
refill water after about 5 min. again; up to the limit line
on its inside mark. (If you refill water during the incubation
period, humidity goes down temporarily.)
2
3
In case you use the incubator without adding humidification
water or intend to incubate eggs at low humidity under 20%,
you must stop its humidification function. (When using
this function, the alarm for sensing water drop will go out.)
[See the description of humidification function ON/OFF on Page 17.]
What's an Incubation Room? / Preparation for Incubation
2. Before use
(2) What is an incubation room? /
Preparation for Incubation
During incubation period, check the water level
about every three days and refill water, if necessary.
(After you refill water, check again after 5min. and refill again.)
The egg to incubate must be a fertilized egg.
(Refer to the guidebook.)
※󰚟How to turn off Humidification Function : Set humidity under 30%.
※󰚟It is recommended to use distilled water or de-ionised water
to prevent alien matter being introduced around
the humidifying heater.
P
U
L
L
O
P
E
N
distilled water
or
de-ionised water
distilled water
or
de-ionised water
LIMIT󰚟IndicationLIMIT󰚟Indication
Some gap (about 2mm) around the eggs is needed
for easy egg turning as shown on the right. ▶
ABS
D
i
vider 10EA
<sold sepa
r
ately
>
ABS
D
i
vider 10EA
<sold sepa
r
ately
>
2. Before use
(2) What is an incubation room? /
Preparation for Incubation
※ When you use the 'universal
rolling divider' which is sold
separately, be careful to adjust
the distance of rolling divider
so that eggs do not roll out of
position. Refer to the picture
rignt side.
Approx.2mmApprox.2mm
The Incubation Room is a confined space for setting and operating an incubator.
Because the incubation room environment has a considerable effect on hatch rate, it's recommended to control
the environment for setting up an incubator; there should be little noise and vibration around and temperature
ranging 20℃-25℃(68-77˚F) with small variation in temperature.
Especially, if there are frequent occasions when the temperature drops suddenly at night, compared with
daytime, be sure to check from time to time and pay attention so that the incubator is not directly exposed to
sunlight during daytime.