User`s manual
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
A
U
T
O
E
L
E
X
ⓐ
1
1
0
V~
1
2
0
V
20
DIGITALINCUBATOR
Unlock and remove the locking buttons for four parts
at the front and back of incubator by pulling them forward.
1
2
3
▶ Pull out the electric cord from the connecting jack and
also take out the plug from the outlet.
Howtodisassembleand
cleantheincubator
▶ When using humidification function, a lot of alien matter sticks
to the humidification heating element ⓐ. This may not cause failure,
but when terminating incubation please clean the humidifying heater
lightly with a soft brush.
▶ If you place the main body(upper part) on the floor,
please don't let the humidification heating part touch with the floor.
The bottom part of incubator should be thoroughly cleaned with water
and dried. The upper part should be naturally dried in the well-ventilated
place for about one day to remove moisture left inside of the incubator
after hatching thoroughly.
You are recommended to use distilled water or de-ionised water
to prevent alien matter being caught in around the humidification
heating part ⓐ.
Don't clean the product with organic solvents such as benzene,
thinner, etc. which may cause deformation or decoloration
of the plastic parts.
If you inflict impact on the humidification heating part or scrape it
with a sharp instrument, the humidifying heater will be damaged.
Don't turn off the power soon after using the incubator,
as this may cause a break down due to moisture left inside
the main controller. At this time, it's better to firstly remove
the water inside of the incubator and dry by operating it for
1 hour and then turn it off or open the view window and dry
it naturally for 2~3 hours and, then, re-operate it, which may
lengthen the life time of incubator.
(Set humidification function OFF. / Refer to the page 17.)
6. How to Clean
(1) How to Disassemble
6. How to Clean
(1) How to Disassemble
W
A
T
E
R
P
U
L
L
O
P
E
N
back
1
1
0
V
~
1
2
0
V