SDS

GLOW STICK
Safety Data Sheet
According to OSHA Hazard Communication Standard 29 CFR 1910.1200
TÜV SÜD Certification and Testing (China) Co., Ltd. Guangzhou Branch Technical Report No.: 64.165.18.00501.02
TÜV SÜD Group
5F, Communication Building, 163 Pingyun Rd, Huangpu West Ave. Engineer: Kevin Zhang
Guangzhou 510656, P.R. China 2018-03-06
Tel.: [phone] , Fax: [phone] Page 3 of 11
5.3. Special protective equipment and precautions for fire-fighters
Protection during firefighting
:
Do not attempt to take action without suitable protective equipment. Self-contained breathing
apparatus. Complete protective clothing.
Other information
:
Evacuate personnel to a safe area. Move containers from fire area if it can be done without
personal risk. Cool tanks/drums with water spray/remove them into safety. Stay upwind. Avoid
breathing vapour or dusts. Provide storage and work areas with suitable fire extinguishers.
Collect contaminated firefighting water separately, it must not enter drains.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
6.1.1. For non-emergency personnel
Emergency procedures
:
Do not breathe dust/fume/gas/mist/vapors/spray. Avoid contact with skin, eyes and inhalation of
vapors
6.1.2. For emergency responders
Protective equipment
:
Do not attempt to take action without suitable protective equipment. For further information
refer to section 8: "Exposure controls/personal protection".
Emergency procedures
:
Stop leak if safe to do so. Evacuate personnel to a safe area;Ensure adequate ventilation,
especially in confined areas;No flames, no sparks. Eliminate all sources of ignition.
6.2. Environmental precautions
Although the product is not classified as dangerous to the environment, it is advised that in the event of an accidental release the product should be
prevented from reaching the sewage system or any water course, and from penetrating the ground/soil. Dispose of spilled material in accordance with
the relevant local regulations. See Section 13 for disposal considerations.
6.3. Methods and material for containment and cleaning up
For containment
:
Isolate the spillage. Ensure adequate ventilation. Collect mechanically. Fill into labeled, suitable
sealed containers for disposal in accordance with local authority regulations
Methods for cleaning up
:
For large amounts: Transfer product into suitable containers.
For residues: Pick up with suitable absorbent material (e.g. sand, sawdust, general-purpose
binder, kieselguhr). Dispose of absorbed material in accordance with regulations
Other information
:
Dispose of materials or solid residues at an authorized site
.
6.4. Reference to other sections
For further information refer to section 13.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Precautions for safe handling
:
Handle in accordance with good industrial hygiene and safety practice
Ensure adequate ventilation, especially in confined areas
Observe personal protective measures listed in section 8.
Do not handle until all safety precautions have been read and understood
Avoid contact with skin, eyes or clothing
Wash contaminated clothing before reuse
Keep away from heat, sparks, flame and other sources of ignition
Avoid breathing vapors or mists
Any deposit of dust which cannot be avoided must be removed regularly.
Hygiene measures
:
Do not eat, drink or smoke when
using this product.
Always wash hands after handling the product.
Remove contaminated clothing and protective equipment before entering eating areas.
Avoid formation of dust, inhalation and ingestion.
Avoid contact with eyes, skin and clothing.