User Manual

www.ReadyLIFT.com - Phone: [phone]
Installation Instructions 69-3486
12
Revised Feb-2014
WARNING TO END USER, INSTALLER AND
SELLER OF THIS PART!
By installing this part you are accepting full responsibility and liability for
proper wheel and tire fitment after installation.
It is the installer’s responsibility to properly align the vehicle before use.
Using a wheel tire fitment combination that results in any contact from the
tire and/or wheels with the new installed ReadyLIFT® upper control arm or
inner fenders at any point including full steering lock will void the Ready-
LIFT® warranty and may result in failure of the ball joints. Failure to do so
may cause damage to your vehicle and/or injury or death to the driver and
passengers.
Final Checks & Adjustments
Post Installation Warnings: Once the vehicle is lowered to the ground, check all parts which have
rubber or urethane components to insure proper torque. Torque wheels to factory specs. Move vehicle
backwards and forwards a short distance to allow suspension components to adjust. Turn the front
wheels completely left then right and verify adequate tire, wheel, brake line, and ABS wire clearance.
Test and inspect steering, brake and suspension components for tightness and proper operation. In-
spect brakes hoses and ABS lines for adequate slack at full extension. Failure to perform the post in-
spection checks may result in vehicle component damage and/or personal injury or death to driver and/
or passengers and void your warranty. Test drive vehicle and re-check the torque of all fasteners and
re-torque wheels on vehicle.
Vehicle Handling Warning
: Vehicles with larger tires and wheels will handle differently than stock
vehicles. Take time to familiarize yourself with the handling of your vehicle
.
Wheel Alignment/Headlamp Adjustment
:
It is mandatory to have a proper and professional wheel alignment performed by a certified alignment
technician. Align the vehicle to factory specifications. It is
mandatory that your vehicle alignment be
checked after any off-road driving. In addition to your vehicle alignment, for your safety and others, it
is necessary to check and adjust your vehicle headlamps for proper aim and alignment.
Vehicle Re-Torque and Safety Inspection:
Upon completion of all services and adjustments performed on your vehicle, and within 50 miles of driv-
ing, check to ensure all fasteners and hardware are properly torqued to specification as noted in the
vehicles factory service manual or the torque chart included.