User Manual

www.ReadyLIFT.com - Phone: [phone]
Installation Instructions 69-3486
8
Revised Feb-2014
Re-install the rear cross member as original.
Install ReadyLIFT® Uni-Ball Control Arm.
38.
37.
Reinstall OEM
hardware
without the
plastic cam
locks into is
original location
noting original
direction of
cam bolts and
marks done
when you re-
moved them.
Add a washer and a standard nut. Tighten down to seat the
43-2.
Install the pin into the spindle.
43-1.
Note:
Steps 43-1
to 43-8 are
the same
for alumi-
num or
steel sus-
pension.
Place the new strut extension spacer onto the strut. Install
strut with spacer leaving nuts loose.
39.
Remove the factory clips, attach the lower strut mount with new
shorter hardware.
When attaching strut to vehicle be sure to
use provided hardware. The serrated
flange nuts go on top and the self locking
nuts with washers go on bottom with
grade 8 bolts.
The OEM lower nut clips and bolts will not
be used. Doing so will cause damage to
you vehicle.
42.
Tighten lower mount then torque the upper strut nuts.
40.
41.