User Manual

www.ReadyLIFT.com - Phone: [phone]
Installation Instructions 69-3486
9
Revised Feb-2014
Connect outer tie rod end and sway bar end links and tighten.
44.
44-1.
Re-attach brake calipers & torque to 145ft lbs.
Remove the standard nut, replace it with a c-lock nut and tighten.
Insert the pin into the lower misalignment spacer.
Lock-tite the upper misalignment spacer and install.
Tighten down the misalignment spacers and install the cap.
Make sure the cap fits nice and tight.
You may need to put a small amount of
grease on the o-ring of the cap to help pre-
vent the o-ring from rolling and binding up.
A trick also is to twist the cap while applying
pressure to achieve a nice and snug fit.
43-6. 43-5.
43-4.
43-3.
43-7. 43-8.