Instructions / Assembly

Using a Long Match or Lighter

1. Prior to lighting, use a shovel to move lava rocks for access to the burner.

2. Wearing heat resistant gloves, position the burning long match or burning butane

lighter near the side of long match or burning butane lighter near the side of

the burner. DO NOT lean over the ﬁre column while lighting!

3. Turn control knob counterclockwise to “LIGHT”.

4. Remove long match/long butane lighter.

5. After lighting, use a shovel and heat resistant gloves to carefully move the lava rocks back

into the proper position and replace the glass panel.

6. After lighting, rotate the Burner Control Knob counter clockwise to “Low” setting. Observe

ﬂame, make sure all burner ports are lit. Flame height should be no higher than 13 inches tall.

7. Adjust the ﬂame to the desired height with the control knob.

When using this method to light your ﬁre column use heat resistant gloves and follow the step by step

instructions. Failure to do so could result in severe injury.

If burner ﬂame goes out during operation, immediately turn the control knob “OFF” and let the gas

clear a minimum of 5 minutes before attempting to re-light the ﬁre column.

Please refer to the trouble shooting pages for additional support beginning on page 15.

WARNING

LIGHTING INSTRUCTIONS