Owner's Manual

ASSEMBLY INSTRUCTIONS

1.) Install the AAA battery as shown in the diagram below

2.) Place (lava rock, glass ﬁller, other) by hand. Do not dump the bag into the burner area, or directly

onto the burner to avoid clogging the burner with dust. Position the ﬁller material across the burn

area to a level 1” above the burner. Make sure that you do not block the igniter housing with ﬁller to

ensure proper ignition and operation.

If using glass ﬁller Real Flame suggests placing a layer of lava rock down ﬁrst around the burner then

adding glass on top of that to improve airﬂow to the burner.

Lava Rock and Glass Filler Warning

1. Do not overﬁll the burner area with rock or glass ﬁller; use only the speciﬁed amount. The depth

of the ﬁller should not be more than one inch above the burner tube. Only Real Flame ﬁller products

have been certiﬁed and tested for safe use with this Real Flame ﬁre column. Using other ﬁller material

may result in increased popping and cracking or increased carbon monoxide emissions.

2. Do not light or use this ﬁre column if the ﬁller is wet. Ensure ﬁller is completely dry before lighting.

Intense heat can cause wet ﬁller to explode and hit someone causing injury.

3. Keep away from the ﬁre column for at least 20 minutes during initial start-up as ﬁller could retain

moisture from manufacturing and shipping.

Igniter Housing