Installation Guide

Rev. 4/26/07
1
2
3
4
5
Step Four
Figure 4
Repeat step three with the remain two
logs. Use figure 4 as reference for
placing the logs.
After all logs have been fastened to Lift
Assembly slowly lower lift arm. If the
top three logs don't rest on Front Log (4)
you may need to adjust the position of the
Rear Log (5) left or right.
Place assembled unit in your existing
fireplace. Add decorative lava rock
around the base of your fireplace.
Step Five
Figure 5
Using your Convert to Gel Log Set
With assembled unit in fireplace, raise lift assembly.
Place two cans of REAL FLAME gel fuel in fuel tray
located in the middle of the grate. With an extended
lighter or long match light gel fuel. Carefully lower
lift handle.
During the initial burn you may experience a slight
odor. This odor is temporary and will be absent on
following burns.
Figure 4
Figure 5
2610 Instructions and warnings for use