Installation Guide
5
SITE SELECTION AND PREPARATION
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp
edge and ensure that the power cord is stored or secured to avoid tripping
or snagging to reduce the risk of fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building
codes and other applicable regulations to reduce the risk of fire, electric
shock or injury to persons.
Do not attempt to wire your own outlets or circuits. To reduce the risk of
fire, electric shock or injury to persons, always use a licensed electrician.
See Figure 1 for grounding instructions.
This heater is for use on 120 volts.
The cord has a plug as shown at A in
Figure 1. An adapter as shown at C is
available for connecting three-blade
grounding-type plugs to two-slot
receptacles. The green grounding lug
extending from the adapter must be
connected to a permanent ground
such as a properly grounded outlet
box. The adapter should not be used
if a three-slot grounded receptacle is
available.
Figure 1
NOTE
• The fireplace insert comes completely assembled and wired. Some tools may be
required to prepare the site and install the trim.
• The assembled dimensions of the fireplace insert are 48.8" wide x 21.7" high x 5.2" deep.
• This fireplace does not require any venting.
Select a suitable location that is not susceptible to moisture and is away from drapes,
furniture and high trac. For ease of electrical hook up you may wish to position the
fireplace near an existing outlet.
NOTE: This adapter is
prohibited in Canada.
NOTE: This adapter is
prohibited in Canada.