Instructions / Assembly

Ambient Light
This will turn the ambient light
above the logs ON/OFF.
OPERATION AND FEATURES
Using the Remote Control
Adjust Brightness
This allows you to raise or
lower the level of flame
brightness.
Adjust Temperature
This allows programming of
the thermostat. The firebox
can be used without the
heater if desired, simply cycle
through the function until
no temperature is displayed.
Press and hold the down
arrow for five seconds to
switch temperature readout
from °F to °C and back.
This allows you to set the
fireplace to automatically
shut OFF after the amount
of time displayed on the
screen. Timer can be set
for ten minutes up to nine
hours.
Dynamic Embers
This function will make the
embers of the fire automatically
glow dimmer and brighter
creating a realistic fire eect.
Timer/Dynamic Embers
This will allow you to set
the automatic shuto
on the fireplace. Hold
for 3 seconds to switch
to Dynamic Embers.
This function will make
the embers of the fire
automatically glow
dimmer or brighter
creating a realistic fire
Hold 3 seconds
to return to Timer.
Power
This will turn the unit ON/
OFF. When turned back
ON, the system will recall
its last heat setting used.
Power
This will turn the unit
ON/OFF.
Adjust Brightness
This function will
cycle through the
flame brightness.
five dierent levels of
Adjust Heater
This function will
cycle through the
dierent temperature
levels of the heater.
Hold 5 seconds
to switch readout
between °F and °C.
Ambient Light
This will turn the
ambient light above
the logs ON/OFF.
Using the Control Panel